UMBC CMSC 313, Computer Organization & Assembly Language,
Fall 2002, Section 0101
DigSim is a Java applet that simulates simple digital circuits. DigSim
was written by I. van Rienen and was released into the public domain (so
it's free). The code is apparently not maintained by anyone anymore. In
fact, the web page most often referenced as the place to get DigSim is no
There are several advantages of DigSim over B2Logic. First,
DigSim is free. I also like the fact that the wires are colored to show
which ones are high (red), which ones are low (green) and which ones
are disconnected (gray). The disadvantages of DigSim compared to
B2Logic are that DigSim has fewer features and it is
harder to set up the system to allow the user to save a schematic
Start DigSim Now.
Running DigSim with Standard Examples
DigSim comes with a suite of standard examples. To run DigSim and play
with these examples, all you need is a Java-enabled browser and point
it at the start page for DigSim. Then,
wait a few moments for the Java virtual machine to start up (actually
could be quite long). You should get a new window with titled "Digital
Simulator" ( like this). You should also
see some new menu items either in a menu bar attached to the window or
in the operating system's menu bar (this is OS dependent). Anyway, find
the "File" menu and select "Open example". You should see a list of
examples. Select one (e.g., "Flip Flop made with two NOR ports") and
press "OK". DigSim should now load the circuit you selected (e.g. an SR
flip flop). To start the simulation, press on the lightning symbol . Now you should be able to play with the circuit
by pushing on switches, etc.
Using DigSim to Design Your Own Circuits
DigSim can also be used to design your own circuits. The catch is that
most web browsers do not want to let a Java applet write to the disk.
(This is usually a very good idea.) Two ways to work around this
problem is listed below. It is a good idea to try saving before doing
anything too complicated. If saving files is prohibited, you'd get a
Java exception error of some kind.
- Convince your web browser that you really want to allow the
DigSim Java applet to write to your disk. Some browsers will let
the applet write to your disk if the applet is stored on the disk
or executed from an appletviewer. You should
download the entire DigSim package if you want to run the applet
- Another method is dispense with the browser or applet viewer
and run DigSim as a Java application. This requires a
wrapper. I included one called "DummyAppletContext" in the DigSim
package. The instructions to do this differ from system to
system, depending on how Java applications are executed.
The following instructions were tested on the Dell computers
in the PC labs at UMBC.
Linux/Unix: You have to be logged into the machine that you
are sitting in front of. At UMBC, this usually means rebooting
the machine into Linux. The exact steps are:
Windows 2000: Java (not the plug-in for the web browsers) must
be installed on the system for this to work. The following sequence
was tested on the Dell computers at UMBC. If you are doing this from
home, download the DigSim package and replace
the directory below with the one where you unpacked DigSim.
In either case, you should get the usual DigSim window, but now it's
running as an application and not an applet so you should be able
to save. Note that when you save, you will have to navigate in the
save dialog back to your home directory. You will not be able to
save files in ...chang/pub/cs313/digsim.
The entire DigSim directory is available as:
6 Nov 2002 12:06:30 EST
to Fall 2002 CMSC 313 Section Homepage